Illustrated Working Principle of the Elastic Vibrating Rapper (Boiler Cleaning Device): Ash-Cleaning Principle in One Drawing
Ash deposits on boiler heating surfaces are a common problem that affects heat exchange efficiency and safe boiler operation, especially strongly adhesive fume, which ordinary sootblowing can hardly remove. The elastic vibrating rapper (boiler cleaning device) uses a mechanical "drop hammer - spring anvil" rapping method that cushions a strong impact into a soft, sustained vibration, making the ash deposits fall off in sheets. The following drawing explains its working principle.
1. Composition
The elastic vibrating rapper (boiler cleaning device) is composed of a drop hammer, a swing device, a drive device and a spring anvil. The drop hammer is connected to the swing end of the swing device to form a pendulum hammer; the swing device is joined to the drive device through a sprocket, and the pendulum hammer lifting height has six positions that can be adjusted freely, which controls the strength of each rap.
2. Working process
During work the drive device lifts the pendulum hammer and then lets the drop hammer fall freely, striking the spring anvil. The spring anvil cushions the high-peak, short-duration impact produced by the drop hammer into a lower-peak, longer-duration impact, while producing a suitable rapping frequency that fully excites the natural-frequency vibration modes of the water wall.
3. Ash-cleaning effect
In this way enough effective vibration is obtained while component stress stays small, and the ash deposits attached to the heating surface slip and detach from the tube walls under sustained vibration, falling in sheets - a good ash-cleaning result for boiler ash deposits.
4. Key points of the drawing
- Drop hammer falling freely: the energy comes from gravitational potential energy, no external high-pressure air supply is needed, and the structure is simple and reliable;
- Spring anvil cushioning: it turns a hard rigid impact into a soft low-frequency oscillation - ash cleaning is forceful yet does not damage the heating surface;
- Exciting the natural frequency: the rapping frequency matches the natural frequency of the water wall, so component stress is small and vibration efficiency is high;
- Wide application: used widely on waste-heat boilers, all kinds of smelting furnaces (side-blowing/bottom-blowing/subliming), fluidised-bed furnaces, waste-incineration boilers, chemical boilers and cement kiln waste-heat boilers.
When selection or an ash-cleaning system retrofit is uncertain, tell the manufacturer the heating surface form, ash deposit characteristics and installation space; Hunan Darui Heavy Machinery Co., Ltd. (website www.hndri.cn, tel. 186-2765-1660) can provide configuration calculation and installation solutions for elastic vibrating rappers.
