News

Home > News > Operation and Maintenance of Screw Conveyors

Operation and Maintenance of Screw Conveyors

Category: Technical  |  Published: 2024-03-28
Screw conveyors are widely used in the building materials, chemical, metallurgical, coal and grain industries. Their normal and effective running is inseparable from daily operation and upkeep, so correct operation and timely maintenance and repair are vital to extending the service life of the equipment and raising production efficiency.
      I. Checks before starting: check whether every part of the screw machine is tight; whether the inlet and outlet ports are clear; whether the oil level of the gear reducer is normal. The starting sequence is: start the motor first, and once it runs normally feed material in evenly. The stopping sequence is: stop feeding first, and stop the motor only after the material inside the screw has run out.
      II. Check the working state of each part often and watch whether any fastener has loosened; if it has, stop the machine immediately and re-tighten it.
      III. Watch whether there is any abnormal noise during running, or any scraping, hitting or rubbing sound; if there is, stop the machine immediately and deal with it.
      IV. After stopping, inspect carefully the wear of the hanging bearings and the lubrication of every part, and top up oil promptly where it is missing.
      V. For the gear reducer use No.30 mechanical lubricating oil in winter and No.45 mechanical lubricating oil in summer; use calcium-based grease for the hanging bearings and the front and rear rolling bearings.
← Back to News List