Application of Screw Conveyors in the Cement Industry
The screw conveyor is a device for moving powdery material. Its structure is comparatively simple and compact, its working performance is reliable and its cost is low, and it is now widely used in the grain industry, building materials industry, chemical industry, transport and other sectors, for instance to convey cement, chemicals, sand, flour and salts. Tubular screw conveyors used for cement keep the cement from flying about, which both cuts waste and reduces environmental pollution, making it a good cement transport device.
With the rapid growth of road building and the continuous improvement of construction machinery, the steep-angle screw conveyor has become an indispensable part of concrete mixing equipment. On building sites that use bulk cement, steep-angle tubular screw conveyors are also often used. This article briefly introduces the structural design and parameter selection of the steep-angle tubular screw conveyor. The steep-angle screw conveyor consists of three main parts: the screw body, the inlet and outlet ports, and the drive unit.
The screw conveyor body includes the head bearing, tail bearing, screw shaft, outer tube, inspection ports and several other parts. The drive unit consists of the motor, the gear reducer and the couplings. The steep-angle screw conveyor is installed at an inclination of about 4 degrees and its length generally does not exceed 8 metres. To keep the screw shaft from bending excessively and rubbing against the outer tube, a support must be added at the middle of the shaft and its deflection must also be checked. The intermediate support is provided to reduce the radial deflection of the screw shaft, and it works under harsh conditions. Because the screw flights are interrupted at the intermediate support, the length of the support along the axis and its transverse size should be kept as small as possible so that material cannot jam there. Supports here may take the form of pedestal bearings or flanged pedestals and similar types.
Each hanging bearing of the screw conveyor must support the connecting shaft reliably and must not pinch or bend the screw. The hanging bearing must be fitted at the centre point of the connecting shaft, and the gap between its end face and the end faces of the two screw tube shafts must exceed 10 mm. To absorb the accumulated length error between the casing and the screw, shims may be added between the flanges of each casing section during installation. Where the centre height of the low-speed shaft of the drive reducer differs too much from the centre height of the screw conveyor, the height of the drive unit can be adjusted with shims. During the no-load test, if oil seepage is found at a bearing, the bearing must be removed and the tightness of the spring inside the seal adjusted until it no longer leaks. During the no-load test the temperature rise of each bearing must not exceed 20 degrees Celsius; if the rise is too high, the hanging bearings are installed in the wrong positions and the connecting shaft is pinched. During the loaded test the temperature rise of each bearing must not exceed 30 degrees Celsius.
To keep fine particles of material from entering the bearings, reliable dust-proofing and lubrication provisions must be made here. Screw conveyors are very sensitive to overload and jam easily; to reach a better conveying state the pitch of the screw shaft is best made variable. The pitch of the lower half should be smaller than the pitch of the upper half, and this arrangement prevents overload jamming of material.
